According to InFocus, the LP530 model provides 2000 ANSI lumens, a contrast ratio of 400:1 alongside a XGA 1024 x 768 resolution. The manufacturer rates the durability of the included lamp at 2000 hours. A look at the light output reveals: The 2000 ANSI lumens are sufficient to illuminate an image width of up to 389 cm in darkened rooms. If room light is present, we recommend not exceeding a maximum width of 259 cm. The projector was released in 2001 and is officially no longer distributed by InFocus. For your information: Compatible lamps for this device are no longer available in stores.
Display Type
1 x DLP Chip XGA 4/3 Ti Digital Light Processing Chip
Ansi-Lumen
Projector
2000 / 1600 im Eco Mode
Screen
667 Lux (200 cm Screen width)
Contrast
400:1 full on/off
400:1 full on/off
Black Level
5,0000 min. Lumen
1,68 min. Lumen
Offset
70% 30 cm over screen top edge →
SCREEN
+Projector
Resolution
XGA 1024 x 768
786.432 Pixel
SXGA 1280 x 1024 compressed
Video Modes
1080i/720p HDTV
Application
Standard-Portabel | External training and company presentations, as well as product presentations. Medium screen width or rooms with little light, max. 100 lumens.
The previous speaker must have had a different projector as the InFocus LP530 is a DLP projector and this only has one color unit.
The device is very reliable and produces a very bright picture which appears clearer and brighter than current projectors with 2500 AL. This is due to the higher lamp output (270 watts) and the significantly higher new price.
Autor:
Frankfurter 28.11.09
3
Stars
My first and worst beamer
Bought the Infocus 2003 after only 1000 hours lamp damage, after another 300 hours it got one of the color panels (Rep 450 Euro) and then after another 400 hours a loud ugly noise and then total loss
Beautiful picture but technically too vulnerable unfortunately.
Autor:
Bruijn, J 10.06.06
4
Stars
LP530
In my opinion a pretty good beamer, but it has its share of problems. Some SMD resistors in the power board tend to break down early in life, making it seem like the lamp is burned out. Replacing those HV resistors in the power board is the solution here.
Eco Mode
InFocus Website
Product Sheet
